Victron Cable f/Smart BMS CL 12-100 to MultiPlus

<p><strong>Cable for Smart BMS CL 12-100 to MultiPlus </strong></p><p>This cable will allow the MultiPlus 500VA – 1600VA, MultiPlus Compact 800VA – 2kVA and MultiPlus-II models to be used with BMS products that have no VE.Bus interface, such as the Smart BMS CL 12-100 and the small BMS. These MultiPlus models can be controlled from the Load/Charge Disconnect outputs and Load/Charger outputs respectively. </p><p><strong>The cable must be wired to the remote on/off connector of the MultiPlus models: </strong></p><ul><li>When used with the MultiPlus 500VA-1200VA models connect the black wire to the ON terminal and the red wire to the (+) terminal. </li><li>When used with the MultiPlus Compact 800VA-2kVA models connect the black wire to the middle terminal and the red wire to the right (IN) terminal. </li><li>When used with the MultiPlus-II models connect the black wire to the lower (-) terminal and the red wire to the upper (+) remote on-off terminal. </li></ul><p>Both the Load/Charge Disconnect outputs of Smart BMS CL 12-100 and Load/Charger outputs of the small BMS must be in ‘High’ state in order for the MultiPlus to operate. After shutdown due to low battery voltage, run the alternator or use a battery charger on the primary side of the BMS to reset the system. The MultiPlus will then switch on and start charging (if connected to an AC power source).</p><strong>Please contact your dealer for any returns, repairs or support issues related to this product.</strong> <!--- cis2:mm5sl5hm --->